Found a carter pump that fits in the stock pump's rubber mount - with a pressure range of 3-5.5 psi. The fitting arrangement isn't ideal, but it works well enough, and there are no mounting configurations to mess with.The facet was as easily available, but I wanted something that would be easily mountable in stock location without major work and that would still be easily available on the road. So far it's about a split, but if the plumbing issues are as easy to address as I hope, this will be worth the extra $20. These things are as available as the facets are and slip right into the rubber bracket that the stock one uses. The hardest part? Getting the rubber mount off the original pump intact. And they are also fully sealed and solid state pumps.
Disclaimer: The information contained on this page and on this site is condensed from the combined wisdom of the members and contributors of the Orange Crush Forum. The contributions are reprinted here exactly as posted by the contributors. The spelling, syntax, grammar, etc have purposely not been corrected in order to retain its original flavor. The contributors are from throughout the World, and English may very well not be their native language. Don't be an ass and complain about the lexicon. It is mostly subjective, with a little objectivity thrown in for seasoning, based on the experiences of the contributors. Use this info at your own risk. The site owner is not responsible for its accuracy or validity. None of the procedures described should be taken as recommendations by anyone. Take anything you read or hear anywhere, but especially on the World Wide Web with a very large dose of salt. The cognoscente is a skeptic.